Bollard Surface Mount 165mm x 1300mm

When a site needs a more commanding physical presence, the 165mm Surface Mount Bollard delivers. Its larger diameter is a clear deterrent against vehicle encroachment into pedestrian zones, building facades and critical infrastructure, and at 1300mm tall it stays visible between parked vehicles and along busy access lanes. Safety yellow with Class 1 red reflective tape satisfies Australian colour-coding requirements for industrial and commercial environments.

No core drilling is required. The surface mount base bolts directly onto existing concrete slabs, which makes it ideal where the slab cannot be penetrated or where bollards are added after the pour. All fixings are included.

Where the 165mm surface mount bollard is used

• Building facades and glazed entries
• Plant, switchboard and equipment protection
• Truck access lanes and yards
• Commercial entrances in coastal or industrial locations

Installation

Mark the four base plate holes, drill 12mm holes into the concrete with a masonry bit, then fix with the supplied M12 x 110mm Trubolt wedge anchors and torque to the anchor manufacturer’s specification. Allow one person about fifteen minutes per bollard on a sound slab. Full method, tools and spacing advice are in our surface mount bollard installation guide.

Specifications

Frequently asked questions

Do I need to core drill to install the 165mm bollard?

No. This is a surface mount bollard. The 225mm base plate bolts to existing concrete with the four M12 x 110mm Trubolt wedge anchors supplied. You only need a hammer drill with a 12mm masonry bit. Follow our step-by-step surface mount installation guide for hole depth, torque and slab requirements.

Surface mount or in-ground: which is right for my site?

Surface mount suits existing slabs, suspended car park decks and any site where the concrete cannot be penetrated. In-ground bollards give higher impact resistance but need a core-drilled or cast footing. Our guide to in-ground versus surface mount bollards compares both.

Does the safety yellow finish meet Australian standards?

Yes. Safety yellow with Class 1 red reflective tape is the recognised colour code for traffic management bollards in Australian car parks and industrial sites, and the reflective tape keeps the bollard visible to drivers at night. See our summary of the bollard rules and AS/NZS standards.

Is a galvanised version available?

Yes. The same 165mm x 1300mm bollard is available hot-dip galvanised for coastal, outdoor and architectural sites where a yellow finish is not wanted.

What is the delivery time and cost?

Bollards are made in Sydney and ship Australia-wide. Freight is calculated at checkout by postcode. Bulk orders for car parks and warehouses can be quoted directly through the contact page.

Browse the full range of Australian-made surface mount bollards, or pair this bollard with stainless steel corner guards and downpipe protectors for complete wall and pipe protection.